Roland VS-82H, Owner'S Manual

Page: 25 / 40

25
Audio Operations
Adjusting Microphone Gain
This adjusts the input sensitivity of microphones connected to the R
channels of AUDIO INPUT connectors 1 and 2.
MEMO
5
Input sensitivity can be adjusted for only the R channel of
AUDIO INPUT connectors 1 and 2. For microphones, make the
connection to the R channel of AUDIO INPUT connector 1 or 2.
5
By default, AUDIO INPUT connectors 1 and 2 are configured
for stereo input. When connecting a microphone, select the
[MENU] button g “AUDIO INPUT” g “ANALOG-1” or “ANALOG-2”
g “MONO INPUT,” and set it to “ON”(monaural input).
1.
Set the volume level of the microphone connected to
AUDIO INPUT connector 1 or 2 to “100 (0 dB).”
You can use either of the following two methods to adjust the
volume level.
5
Change the display to the audio volume control screen, then
raise the channel fader to the “100” (0 dB) position.
For more information on how to do this, refer to “Using Audio
Faders to Adjust the Volume Level” in the column at right.
100 (0 dB)
5
Select the [MENU] button g “AUDIO INPUT 1” g “ANALOG-1” or
“ANALOG-2”
g
“INPUT LEVEL,” and set this to “100 (0 dB).”
2.
Select the [MENU] button
g
“AUDIO INPUT”
g
“ANALOG-1”
or “ANALOG-2” g “INPUT GAIN.”
3.
Turn the [VALUE] dial all the way counterclockwise to
lower the input sensitivity.
4.
Slowly turn the [VALUE] dial clockwise to adjust the input
sensitivity.
While inputting actual audio, turn the [VALUE] dial to increase and adjust the
input sensitivity.
5.
Press the [MENU] button to quit the menu.
Adjusting the Volume Balance of Input
Audio
This adjusts the volume balance of the audio input to the unit.
NOTE
Even when an HDMI connection is used, no HDMI audio is input
unless “HDMI” has been selected in the settings for the video
input channel (p. 19).
Using Audio Faders to Adjust the Volume Level
You operate the audio faders shown on the display to adjust the
volume levels.
1.
Before you start, make the settings for the audio input
channels assigned to the audio faders on the display (p. 18).
2.
Use the cursor buttons to switch the display to the screen
for audio volume control (p. 18).
3.
Raise or lower the audio faders to adjust the volume
balance for each channel.
Turn the [VALUE] dial to select the audio fader to operate (1 through
8), then press the [VALUE] dial to apply the selection.
Turn the [VALUE] dial to adjust the volume level of the input channel.
Pressing the [VALUE] dial once more lets you select the audio fader
to operate.
Using the Menus to Adjust the Volume Level
1.
Select the [MENU] button g “AUDIO INPUT” g “HDMI-1”
through “HDMI-8” or “ANALOG-1” through “ANALOG-8”
g
“INPUT LEVEL,” then adjust the volume level.
2.
Press the [MENU] button to quit the menu.