Roland VS-1680 V-XPANDED, User Manual, Page: 93 / 282

93
Chapter 6 Mixer Channel Strip Detail
Chapter 6
the source, and use the TIME/VALUE dial to place a mark
for all sources to be assigned to the track.
[F3 (Solo)] SOLO
Use this to turn the SOLO function on and off for a mixer
channel.
[F4 (Mute)] MUTE
Use this to turn the MUTE function on and off for a mixer
channel.
[F5 (Fader)] FADER
Controls the level (0-127) of the signal.
Master Block
The following functions are found in the Master Block
section of the mixer. Press [EDIT/SOLO] to view and adjust
the settings of the Master Block. Press the function button
located under the display corresponding to the setting you
wish to change. Or, press [ ], [ ], [ ], and [ ]
to move the cursor to setting you wish to change. Use the
TIME/VALUE dial to select the desired value.
[F1 (MST)] MASTER
Adjusts the level and balance of the master mix.
Level
This adjusts the volume level (0-127) for the MASTER OUT
jacks. This is normally adjusted using the Master fader.
Balance
This adjusts the left-right balance (L63-R63) for the MASTER
OUT jacks.
[F2 (MON)] MONITOR
Adjusts the level and balance of the Monitor mix.
Level
This adjusts the volume level (0-127) for the MONITOR jack.
This is normally adjusted using the MONITOR knob on the
top panel.
Balance
This adjusts the left-right balance (L63-R63) for the
MONITOR jacks.
[F3 (AUX.A)] AUX A
This selects the signal to be assigned to the AUX A jacks.
EFX1:
The signal at the EFFECT 1 bus.
EFX2:
The signal at the EFFECT 2 bus.
AUX1/EFX3:
The signal at the AUX1 bus, or, when a second VS8F-2 Effect
card is installed in the VS-1680, the EFFECT 3 bus.
AUX2/EFX4:
The signal at the AUX2 bus, or, when a second VS8F-2 Effect
card is installed in the VS-1680, the EFFECT 4 bus.
AUX3/AUX:
The signal at the AUX3 bus, or, when a second VS8F-2 Effect
card is installed in the VS-1680, the AUX bus.
[F4 (AUX.B)] AUX B
This selects the signal to be assigned to the AUX B jacks.
EFX1:
The signal at the EFFECT 1 bus.
EFX2:
The signal at the EFFECT 2 bus.
AUX1/EFX3:
The signal at the AUX1 bus, or, when a second VS8F-2 Effect
card is installed in the VS-1680, the EFFECT 3 bus.
AUX2/EFX4:
The signal at the AUX2 bus, or, when a second VS8F-2 Effect
card is installed in the VS-1680, the EFFECT 4 bus.
AUX3/AUX:
The signal at the AUX3 bus, or, when a second VS8F-2 Effect
card is installed in the VS-1680, the AUX bus.
[F5 (DOUT1)] DIGITAL OUT 1
This selects the signal to be assigned to the DIGITAL OUT 1
(coaxial) connector.
MST:
The signal at the MASTER jacks (MIX bus).
MON:
The signal at the MONITOR jacks.
EFX1:
The signal at the EFFECT 1 bus.
EFX2:
The signal at the EFFECT 2 bus.