Roland VS-1680 V-XPANDED, User Manual, Page: 186 / 282

186
Chapter 14 Other Useful Functions
3.
Press [ ], and [ ] to move the cursor. Use the
TIME/VALUE dial to adjust each of the settings as
desired.
Stereo In Select
This setting determines which external input is assigned
to the STEREO IN bus.
Off:
The STEREO IN bus is not used.
Input 1/2:
Assigns INPUT jacks 1 and 2 to the STEREO IN bus.
Input 3/4:
Assigns INPUT jacks 3 and 4 to the STEREO IN bus.
Input 5/6:
Assigns INPUT jacks 5 and 6 to the STEREO IN bus.
Input 7/8:
Assigns INPUT jacks 7 and 8 to the STEREO IN bus.
Digital:
Assigns the DIGITAL IN connector (coaxial or optical) to
the STEREO IN bus.
Level:
Adjusts the volume level (0-127) of the STEREO IN bus.
Balance:
Adjusts the balance (L63—R63) for the STEREO IN bus.
4.
Press [PLAY (DISPLAY)] to return to the Playlist display.
5.
Adjust the STEREO IN bus level using the channel fader.
6.
Press [FADER/MUTE] so the “IN” indicator is lit.
7.
Use the ST IN fader to adjust the STEREO IN bus level.
8.
After you’re finished adjusting the STEREO IN bus level,
press [FADER/MUTE] so “TR” is lit.
* You can quickly assign an INPUT jack to the STEREO IN
bus by holding [ST IN] and pressing the SELECT button for
the input you want. The inputs are assigned in pairs (Inputs 1
and 2, Inputs 3 and 4, Inputs 5 and 6, etc.).
Removing a Direct Current
Offset from the MIX Bus
When the level meters of a device (mixer etc.) connected to
the output of the VS-1680 may move even though no sound
is being output from the VS-1680, you may be experiencing a
direct current offset on the MIX bus that is being output from
the VS-1680’s MASTER outputs. This can be removed.
1.
Press [PLAY (DISPLAY)].
2.
Hold down [SHIFT] and press [F5 (SYSTEM)].
3.
Make sure that the System Menu is displayed. If not,
press [F6 (EXIT)].
4.
Press [PAGE] so that [F2] indicates “GLOBL,” and then
press [F2 (GLOBL)].
5.
Use [ ], [ ], [ ], and [ ] to move the
cursor to “DC Cut,” and use the TIME/VALUE dial to
select the desired setting.
If “DC Cut” is not shown, press [F2 (Prm2)], and turn the
TIME/VALUE dial.
DC Cut
When this is turned on, any direct current offset on the MIX
bus will be removed before the VS-1680 MASTER outputs.
6.
Press [PLAY (DISPLAY)].
Using the MONITOR Knob to
Adjust Channel Panning
You can use the MONITOR knob to directly adjust the pan
(or balance) of the specified channel.
1.
Press [PLAY (DISPLAY)].
2.
Hold down the [SELECT] button for the channel whose
pan you wish to adjust, and do so by turning the
MONITOR knob.
Be Careful!
If you turn the MONITOR knob without pressing
[SELECT], you will adjust the volume level. If you are
attempting to adjust panning and inadvertently turn the
MONITOR knob toward the right without pressing
[SELECT]—or if you let go of [SELECT] while turning
the knob, a high-volume noise capable of damaging your
amp or speakers may occur.