69
Advanced Use
If you press the VIBRATO AND CHORUS [UPPER]
button, the setting will return to its initial value.
3.
Press the [WRITE] button to confirm the settings.
This saves the settings.
The indicators for the [1]–[8] buttons light up while the
settings are being saved.
NOTE
Never turn off the power while parameters are being
saved.
❍
ORGAN AFTER ASSIGN
This selects the function whereby the sound is controlled
by the velocity used in the Upper Part.
1.
Hold down the [BANK] button and press the [VIBES]
button.
The indicators of [1]–[8] buttons ([1] button) will blink.
2.
Press one of the [1]–[8] buttons ([1] button) to select the
function.
There are nine parameters. You can select all of these
parameters by controlling the lighted/extinguished state
of the [BANK] button’s indicator.
The following parameters are assigned to each button.
[BANK] button’s indicator extinguished
[BANK] button’s indicator lighted
If you press the VIBRATO AND CHORUS [UPPER]
button, the setting will return to its initial value.
When you want to stop editing, press the [H-BAR
MANUAL] button.
3.
Press the [WRITE] button to confirm the settings.
This saves the settings.
The indicators for the [1]–[8] buttons light up while the
settings are being saved.
NOTE
Never turn off the power while parameters are being
saved.
The volume of the spring shock can be adjusted with the
REVERB [LEVEL] knob. The spring shock is particularly
effective if “SPRING” is selected as the reverb type (p.
45).
NOTE
When the “SPRING SHOCK” function is assigned to the
aftertouch, please be aware that raising the reverb level
excessively will produce a high-volume impact sound.
NOTE
The aftertouch has no effect when the D BEAM [ON]
button is off while “D BEAM SYNC” is assigned to
aftertouch.
Button
Parameter
[1]
OFF
Nothing is assigned.
[2]
ROTARY SLOW/FAST
The rotary speaker effect can be switched
between slow and fast. This will have the same
effect as the [SLOW/FAST] button.
[3]
ROTARY BRAKE
This button temporarily halts the rotation of the
rotary sound.
[4]
OVERDRIVE
The depth of overdrive will be controlled.
[5]
CRESCENDO
By pressing the keys down, you can gradually
increase the volume for all the harmonic bars.
When you press down fully on the keys, the
harmonic bar volumes will be at maximum, and
the rotary will switch to FAST. When you
reduce the pressure on the keys, the volume
decreases.
[6]
RING MODULATOR
Pressing down on the keys causes the ring
modulation to be applied (p. 43). The amount of
ring modulation applied varies according to
how much pressure is placed on the keys.
[7]
TONE WHEEL BRAKE
The wheel brake will be applied (p. 43).
[8]
SPRING SHOCK
This lets you produce the sound of a spring
reverb unit being jarred (p. 43).
Button
Parameter
[1]
D BEAM SYNC
The same function that is assigned to the D
BEAM controller will also be assigned to the
aftertouch. When you change the function that
is assigned to the D BEAM controller, the
function that is assigned to the aftertouch will
also change.
Button
Parameter
VK-88_e.book 69 ページ ２００４年４月２０日 火曜日 午前９時０分
