Roland VIMA JM-8, Owner'S Manual

Page: 103 / 176

Using MIDI Sets
VIMA JM-8
r
103
Using MIDI Sets
MIDI Sets are memories for MIDI settings. The JM-8 pro-
vides eight MIDI Set memories that you can use to load
and save settings for various MIDI configurations. You
can specify which MIDI Set should be loaded when you
switch on the JM-8 (see below). If you need to reset
some or all MIDI parameters to their default values,
select PRESET
[EXTERNAL¥IN]
or
[SONG¥PART]
rather
than a MIDI Set.
Writing a MIDI Set
(1) Press the [EXIT] button repeatedly
until it stops flashing to return to the main page (if
necessary).
(2) Press
[MENU]
‰
[ADVANCED]
‰
[MIDI]
.
(3) Press the
[WRITE]
display button (it lights red).
(4) Press the field that corresponds to the MIDI Set
where you wish to save your MIDI settings (
[1]
~
[8]
).
The display briefly shows the “Operation Complete”
message.
(5) Press the [EXIT] button repeatedly until it stops
flashing to return to the main page.
Selecting MIDI Sets
(1) Press the [EXIT] button repeatedly until it stops
flashing to return to the main page (if necessary).
(2) Press
[MENU]
‰
[ADVANCED]
‰
[MIDI]
.
(3) Press the MIDI SET
[1]
~
[8]
display button that corre-
sponds to the MIDI Set that you want to use (the
two PRESET display buttons are “switched off”).
(4) Press the [EXIT] button repeatedly until it stops
flashing to return to the main page.
MIDI Set selection at power-on
When you switch on the JM-8, it automatically selects
default MIDI settings. If they do not match the settings
required for your setup, you can tell the JM-8 which
MIDI Set it should recall when you switch it on:
(1) Press the [EXIT] button repeatedly until it stops
flashing to return to the main page (if necessary).
(2) Press
[MENU]
‰
[ADVANCED]
‰
[UTILITY]
.
(3) On the page that appears now, press the
[STARTUP]
display button.
(4) Press the
[MIDI¥SET]
display field and use the dial to
select the MIDI Set (1~8) to be recalled when the
JM-8 is switched on.
(5) Switch on the
[RECALL]
display button to the left.
Switch off this display button if no MIDI Set should
be recalled when the JM-8 is powered on.
JM-8_OM_GB.book Page 103 Wednesday, July 29, 2009 4:43 PM