Roland VersaSTUDIO BN-20A, User Manual

Page: 93 / 120

If the print-head carriage stops over the platen, take action immediately to prevent the heads from
drying out.
What to Do First
Hold down the [POWER] key for one second or longer to switch the sub power off, then back on. If the
media is jammed, then also remove the media.
If the print-head carriage move to the standby position (on the right side of the machine), it means
the operation has ended successfully.
If The Heads Still Do Not Move
Try switching off the main power, then again switching on the main power, followed by the sub power.
If the print-head carriage move to the standby
If the heads still do not move after "What to Do First" is performed, carry out the following emergency
response measure, then contact your authorized Roland DG Corp. dealer.
Procedure
1.
Switch off the main power and open the front cover.
2.
Gently move the print heads to the standby position.
Stopping at the place where the audible click is heard locks the print heads in place.
The Print Heads Stop Moving
92
Machine Problems