Roland VersaSTUDIO BN-20A, User Manual

Page: 81 / 120

Output Quality Problems
Printed results are coarse or contain horizontal stripes..........................................81
Do the print heads show nozzle clogging? ....................................................81
Have you carried out[Calibrate Sheet Feeding] ? ..........................................81
Have you carried out [Bidirectional adjustment] ? ........................................81
Is the temperature of the room too low?.....................................................81
Is the printer installed in a level and stable location? .....................................81
Is the printer installed in a location out of direct sunlight? ...............................81
Is the media loaded and set up correctly? ...................................................81
Colors are unstable or uneven........................................................................82
Did you shake the ink cartridges gently before installing them? .........................82
Is the media wrinkled? ..........................................................................82
Is the printer installed in a level and stable location? .....................................82
Is the printer being used in a location subject to severe changes in the operating en-
vironment? ..................................................................................82
The media becomes soiled when printed ...........................................................83
Are the print heads dirty?.......................................................................83
Cutting is misaligned or skewed......................................................................84
Is the media loaded and set up correctly? ...................................................84
Are the settings for the cutting conditions appropriate? ..................................84
Is the length of output too long?...............................................................84
Are you using media that exhibits large expansion and contraction? ....................84
The printed surface is damaged when cutting .....................................................85
Does the tip of the blade holder cap scrap the printed surface? .........................85
80
Output Quality Problems