Accommodating to the Types and Condition of Media
4
Part of
Practice
100
Description
This makes the setting for distance from the left or right media clamp to the corresponding left or right edge
of the printing area. You can select either "5 mm", "10 mm," or "25 mm." Setting this to "5 mm" lets you expand
the printing area.
P. 130, "Maximum Area and Margins"
Note, however, that when you're using transparent media, setting this to "5 mm" may result in printing on
top of the media clamps.
Default Setting
[SIDE MARGIN]: 10 mm
Preventing Soiling of the Media and Dot Drop-out
Procedure
Press
.
Press
several times to display the left figure.
Press
.
Press
several times to display the left figure.
Press
.
Press
to select an item.
PAGE
Automatic cleaning is performed every time before printing starts.
10 to 990 min
Automatic cleaning is performed when the cumulative printing time
reaches the value you set here.
NONE
Automatic cleaning is not performed.
Press
to enable the setting.
Press
to go back to the original screen.
Description
In the following cases, Ink tends to collect on the surface of the heads. Under some conditions, this ink may
be transferred to the media or cause dot drop-out. Use this feature at such times.
When you use media prone to buildup of static charge.
When the ambient temperature is low.
When the head height is set to “HIGH.”
Selecting "PAGE" or a value from "10 min" to "990 min," the ink buildup is removed before or during printing
while printing is performed. Note, however, that using "PAGE" or a value from "10 min" to "990 min," results
in longer printing times.
Default Setting
[PERIODIC CL.]: NONE
MENU
SUB MENU
SUB MENU
PERIODIC CL.
PERIODIC CL .
NONE 10 min
W1200mm
SETUP SHEET
Current
setting
Setting after
change