Getting Ready
10
Making the Power Automatically Turn off After a
Time (AUTO OFF)
The power to this unit will be turned off automatically after
a predetermined amount of time has passed since it was
last used for playing music, or its buttons or controls were
operated (Auto Off function).
If you do not want the power to be turned off automatically,
disengage the Auto Off function.
* Unsaved data is lost when the power turns off. Before turning the
power off, save the data that you want to keep.
* To restore power, turn the power on again (p. 9).
1 .
Press the [SETUP] button.
2 .
Use the PAGE [UP] [DOWN] buttons and the function
buttons to select “AUTO OFF.”
The AUTO OFF screen appears.
3 .
Use the [–] [+] buttons or the dial to specify the
setting of the auto-off function.
Value
Explanation
OFF
The power does not turn off automatically.
4 HOURS
When four hours have elapsed without
any pad being struck or any operation
being performed, the unit will turn off
automatically.
4 .
Press the [KIT] button to return to the DRUM KIT
screen.
MEMO
If the auto-off function is set to “4 HOURS,” the message “WARNING:
AUTO OFF, The TD-50X will turn off in 30 min.” will appear 30
minutes before turning the TD-50X off.
Making Hi-Hat Settings
When using the VH-14D digital V-hi-hat or the VH-13, VH-11 or VH-10
V-hi-hats, adjust the offset on the TD-50X.
This adjustment is required for pedal movements such as open or
close to be detected correctly.
Settings for the VH-14D
1 .
Press the [TRIGGER] button.
2 .
Press the PAGE [UP] button several times to access
the top page.
3 .
Press the [F4] (HI-HAT) button.
The TRIGGER HI-HAT screen appears.
*
“VH-14D”
is not shown as a Trig Type when the VH-14D is not
connected or if it is not assigned as the hi-hat. In this case, connect
the VH-14D and assign it as the hi-hat (p. 7).
4 .
Press the [F5] (OFFSET) button.
The VH OFFSET ADJUSTMENT screen appears.
5 .
Loosen the clutch screw of the top cymbal and let it
sit on the bottom cymbal.
* Do NOT touch the hi-hats or the pedal.
Clutch screw
6 .
Press the [F5] (EXECUTE) button.
The “VH Offset” parameter is set automatically (approx. 3 seconds).
The [TRIGGER] button stops flashing and remains lit.
7 .
Press the [KIT] button to return to the DRUM KIT
screen.
If you need, make further adjustments to the parameters.
&
“Reference Manual” (PDF)