Roland V-Drums TD-20X, Owner'S Manual

Page: 101 / 156

101
Chapter 8. Trigger Settings for Each Pad [TRIGGER]
When two pads are mounted on the same stand, hitting one
pad may trigger the sound from another pad unintentionally.
(This is called “crosstalk.”) Eliminate this by adjusting Xtalk
Cancel on the pad that is sounding inadvertently.
In some cases, you can prevent crosstalk between two
pads by increasing the distance between them.
1.
Press the [TRIGGER] button.
The [TRIGGER] button lights.
2.
Press the [F4 (XTALK)] button.
If [F4 (XTALK)] is not shown, press the [F1 (BANK)] button
once to access the “TRIGGER BANK” screen.
3.
Use the [F1]–[F3] buttons to select the parameter.
fig.08-013-xtalk.eps_70
The graph in the right side of the screen is a “velocity
monitor” that shows the force (velocity) of your strike. It
shows the velocities of the sixteen most recent strikes.
4.
Select the pad for which you want to make settings.
Strike the pad, or use the TRIG SELECT buttons to select it.
You can also use the [CURSOR] buttons to select the pad.
5.
Use the [-] [+] buttons or the [VALUE] dial to adjust
the setting.
6.
When you’re finished, press the [EXIT] button to
return to the “DRUM KIT” screen.
Eliminate Crosstalk Between
Pads [F4 (XTALK)]
Parameter Value Description
[F1 (XTALK)] button
XTALK CANCEL
5–80
Strength of crosstalk
cancelling (steps of 5)
OFF
Crosstalk cancellation will be
turned off
[F2 (MOUNT)] button
MOUNT TYPE
Select the pad mount type here.
SEPARATE Set independently
PAD Using a pad mount
CYMBAL Using a cymbal mount
[F3 (GROUP)] button
XTALK GROUP 1–8
Crosstalk Cancel affects the
pads set to the same number.
Crosstalk example: If you hit the snare pad
and the tom 1 also sounds
Set the snare and tom 1 to the same group.
Raise the “XTALK CANCEL” for the pad being used for
the tom 1. The tom 1 pad will be less prone to receive
crosstalk from other pads.
With a setting “OFF,” crosstalk prevention will not work.
If the value is set too high, and two pads are played
simultaneously, the one that is struck less forcefully
may not sound. Be careful and set this parameter
to the minimum value required to prevent
crosstalk.
TD-20X_e.book 101 ページ ２００９年６月８日 月曜日 午後３時５０分