99
Applying Effects to the Sound
The Display shows several Factors at a time. If necessary, Scroll up or down the Display to find the Factor
to be edited.
fig.12-16
1.
Press the
[MENU]
button so it’s lighted, and access the
MENU
screen.
2.
Turn the
[VALUE]
knob to select “
Patch Settings
,” and press the
[VALUE]
knob.
3.
Turn the
[VALUE]
knob to select the factor that you want to edit, and press the
[VALUE]
knob.
4.
Turn the
[VALUE]
knob to specify the value, then press
[EXIT]
.
5.
Repeat steps 3 – 4 to set patch factors.
6.
PATCH TOP
screen without saving, the
PATCH TOP
screen will indicate
<
>
, reminding you that the
patch settings have been modified.
*
If you turn off the power or select a different patch while the display indicates
<
>
,” your edited patch will be
lost.
fig.12-18
Chase Switch
Switches the Chase function on and off. The Chase Play function
makes it possible to output the Lower Tone slightly later than the
Upper Tone, which is actually played on the keyboard. This
function, however, is only available in
Dual
or
Whole
Key Mode.
Value:
Off, On
fig.12-19
Portament Switch
Switches the Portamento function on and off. Portamento is a
slide from one pitch to another, and is often used for violin
performance.
Value:
Off, On
fig.12-20
Key Mode
Key Mode
refers to the Upper and Lower Tones are played on the
keyboard.
Value:
Whole, Dual, Split, Separate, Whole-S, Dual-S, Split-US,
Split-LS, Separate-S
How to Make the Patch Factors
vc1_e.book 99 ページ 2004年4月2日 金曜日 午後3時21分
Summary of Contents for V-Card VC-1
Page 154: ...154 Index vc1_e book 154...