Roland V-Card VC-1, Owner'S Manual

Page: 19 / 156

19
Applying Effects to the Sound
The performance controlling functions (we call them factors in this manual) in each Patch can be edited
by taking the following procedure.
A patch consists of several Factors as show below.
fig.05-01e(PatchFactorImage)
fig.05-02(Panel_TimeTripButton)
You can apply a variety of effects by touching your fingertip to the Time Trip pad
located at the left side of the V-Synth’s front panel. The Time Trip Pad settings are
saved with each patch. This means that you can create patches that contain Time
Trip Pad settings you like.
1.
Access the PATCH TOP Screen.
2.
Choose the function that you want to control from the Time Trip pad, and press
the
TIME TRIP PAD button for that function.
3.
While you play the keyboard to produce sound, place your fingertip on the Time Trip pad and move your
finger in the following way.
If [TIME TRIP] is on
Using the Time Trip Pad , the following two volume balance controls can be adjusted at the same time.
• Volume balance of the two Partial sounds of either Tone ; Upper or Lower.
• Volume balance of the Upper and the Lower tones.
Applying an Effect by Touching to the Pad
Button Functions
[TIME TRIP] This provides the same effect as the D-50’s joystick (tone balance or partial balance).
[ASSIGNABLE] Apply the effect that is specified by each patch. (CTRL Setup; p. 26)
[HOLD]
you can cause the effect to be held even after you take your finger off the Time Trip
pad.
Variations of
Control Functions
Tone Tune
Tone Tune
UPPER Tone
Key Mode
LOWER Tone
Tone
Balance
Output Mode
(Reverb, etc.)
vc1_e.book 19 ページ ２００４年４月２日 金曜日 午後３時２１分