Roland V-Card VC-1, Owner'S Manual

Page: 104 / 156

104
Transferring Patches To and From the D-50/550
The transferred patch data (64 patches) will be lost if you turn off the power. Be sure to save the data.
fig.12-24a
1.
Press the [MENU] button so it’s lighted, and access the MENU
screen.
2.
Turn the [VALUE] knob to select “ Bank Save ,” and press the
[VALUE] knob.
fig.12-24aa
3.
The display will ask “Are You Sure?” Press [VALUE] knob once
again to carry out the bank save operation.
When the operation is completed, the display will indicate
“
Completed! ”
Using the D-50
1.
Use a MIDI cable to connect the VariOS’s MIDI OUT connector to the D-50’s MIDI IN connector.
2.
Set the D-50 and VariOS to the same MIDI channel (the basic channel; p. 117).
3.
Turn the MIDI Mode of the VariOS to Internal (p. 119).
4.
Turn the Memory Protect of the D-50 to OFF .
4-1.
Press the [TUNE/FUNCTION] button.
4-2.
Select “ Protect ” with the Selector button and turn it OFF with the joystick.
5.
Enable reception of bulk load data on the D-50.
5-1.
Press the D-50’s [DATA TRANSFER] button.
5-2.
While pressing the D-50’s [DATA TRANSFER] button, specify (B.Load) with the Selector
button .
5-3.
Press the D-50’s ENTER] button.
6.
Turn the Exclusive Sw of the VariOS to On .
fig.04-05c
6-1.
Press the VariOS’s [MENU] button so it’s lighted, and
access the MENU screen.
6-2.
Turn the VariOS’s [VALUE] knob to select “ MIDI Setting ,”
and press the [VALUE] knob.
Saving Transferred Patches with the VC-1
Transferring Patches from the VC-1 to the D-50/550
13 4-1 5-3 5-1, 5-2 4-2
vc1_e.book 104 ページ ２００４年４月２日 金曜日 午後３時２１分