29
Basic Operations
2. Select a transition effect.
Use the [WIPE PATTERN] buttons to select the transition effect you want to apply.
* Using the [CUT] button makes the video change instantly, with no transition effect applied.
fig.transition-select.eps
Start
Finish
CUT
A
No transition effect is applied.
MIX
A
AB
Video sources blend together during the
switch process.
2
A
A
1
A
Video sources wipe from one to the other
during the switch process.
(default : horizontal wipe).
B
B
B
B
B
Video sources wipe from one to the other
during the switch process.
(default : vertical wipe).
A
B
3. Set the transition time.
Operate the [TRANSITION] dial to set the time for which the transition effect is applied.
fig.transition-time.eps
4. Select the video you want to output next.
Use the input selectors in the [B-BUS/PST] section to select the channel of the video you want to output next (standby). The
indicator for the pressed button lights up green. In the [INPUT] mode of the preview monitor, a green border is displayed around
the selected channel.
fig.standby-channel.eps
Green
5. Output the selected video.
Press the [AUTO] button. The final output changes to the video on the channel selected in step 4.
* When a [WIPE PATTERN] button other than [CUT] has been selected, the [AUTO] button indicator flashes while the transition effect is applied.
fig.press-AUTO.eps
When the transition is complete, the input selector in the [A-BUS/PGM] section for the channel selected in step 4 lights up red.
Also, in the [INPUT] mode for the preview monitor, a red border is displayed around the video on that channel.
The channel that was output before the [AUTO] button was pressed changes to the standby channel at this time.
While the transition is in progress (that is, while the transition effect is being applied), the [AUTO] button indicator flashes.