21
Connecting External Equipment
Connecting Audio Sources
Connect audio mixers or other audio sources to the AUDIO INPUT connectors. Input made via these connectors is output from
HDMI connectors in the OUTPUT 1/2 sections together with the results of video mixing on the V-40HD.
* When connection cables with resistors are used, the volume level of equipment connected to the inputs (AUDIO INPUT) may be low. If this
happens, use connection cables that do not contain resistors.
fig.audio-connection.eps
Audio Mixer
This unit is equipped with balanced (TRS) type jacks. Wiring diagrams for these jacks are shown below. Make connections after first checking the
wiring diagrams of other equipment you intend to connect.
fig.TRS_jack.eps
Use the menus to adjust the audio level (p. 37) or delay its timing to sync it with the video (p. 38).
Sharing a Source Between Channels
Channels 1 through 4 can share a source. Using this feature, you can assign the video on channel 1 to channels 2 through 4. When
shared, a single source video is assigned to multiple channels. To share a source, go to the Input menu (p. 45) and select [Shared
Input] in the input format display area.
* Only the source of the previous adjacent channel can be shared. Therefore, when sharing the source on channel 1 with channels 2 through 4,
[Shared Input] must be selected for each channel from 2 to 4.
fig.shared-input.eps
HDMI
RGB/
Component
Composite
Shared
Input
HDMI
RGB/
Component
Composite
Shared
Input
HDMI
RGB/
Component
Composite
Shared
Input
HDMI
RGB/
Component
Composite
Ch 1
Ch 2
Ch 3
Ch 4
Audio sources cannot be shared.