Setting the Base Point
Set the base point in order to determine the area on the loaded media in which to print (the output area).
The base point ( ) indicates the right edge of the output area ( ). ( : Media feed direction, : print-
head carriage movement direction) You can print without setting the base point, but setting the output
area enables you to use media without being wasteful and also to print on the targeted location.
Set the base point for each individual page. When the printing of one page finishes, the base point returns
to its default value.
• Note that the left and right positions are not restored to their defaults for test patterns.
MEMO
Procedure
1.
Tap
.
2.
Tap
[Move].
The movement screen appears.
3.
Tap
,
,
or
to move the center of the blade to the position that you want to set
as the base point.
Tap
or
to move the media. Tap
or
to move the cutting carriage.
Adjusting the Output-start Location
208
Optimizing Work Efficiency
Summary of Contents for TrueVIS VG3-540
