Fine-tuning the Cutting Conditions
You can accurately set items such as the blade force, movement speed, and blade offset to match the na-
ture of the media and the shape to cut. First, perform a cutting test, and then determine and enter the
setting values. After entering the setting values, perform a cutting test again and check the results. Re-
peat the process of performing a cutting test and making the settings several times to find the optimal
setting values.
Procedure
1.
Load the media.
2.
Close the front cover.
3.
Tap
[Blade Adjustment] on the home screen.
4.
Tap [Execute] next to [Cutting Test].
The test pattern is cut.
5.
Check the results of the cutting test.
If the results are difficult to see, [Execute] [Sheet Cutting], separate the media, and then hold it
to check the results.
Check item
Result
Setting item
Adjustment
Check the shape.
The cut shape is distorted.
[Cutting Speed]
Reduce
Peel off the circle.
The square also peels off.
[Blade Force]
Increase
Some uncut areas remain.
[Cutting Speed]
Reduce
Peel off the square.
The blade leaves faint traces on the backing
paper.
[Blade Force]
No change
The blade trace is indistinct.
Increase
The blade trace is too deep and cuts into the
backing paper.
Reduce
Accurately Adjusting the Cutting Settings
Optimizing the Output Quality
179
Summary of Contents for TrueVIS VG3-540
