Roland TrueVIS VG3-540, User Manual

Page: 175 / 341

Drying the Trailing Edge of the Printing Area on the Dryer
To dry the ink thoroughly, configure the settings so that the media is fed until the trailing edge of the
printed area is put on the dryer after the printing is finished.
Procedure
1.
Load the media.
2.
Tap .
3.
Tap [Media Settings]>[Heater Settings]>[Dry After Printing].
4.
Tap to turn it on.
[Drying Feed (Printing Only)] This setting applies to output data designed only for printing. This setting is ignor-
ed for output data designed for printing and cutting. The margin between the
print-end position and the next print-start position is set to a value of 130 mm
(5.12 in.) when [Extended Dryer] is set to [Disable] and 310 mm (12.2 in.) when
it is set to [Enable].
[Drying Feed (Printing & Cutting)] This setting applies to output data designed for printing and cutting. This setting
is ignored for output data designed only for printing.
(On)
Media feed is performed until the trailing edge of the printing area is positioned
on the dryer.
(Off)
Media feed stops when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent print-
ing operation.
5.
Tap or to set the drying time for [Drying Time (Printing Only)] or [Drying Time (Printing &
Cutting)].
Drying Time
• The next operation is not started until the set time elapses.
• Tap [Skip] during drying to finish the drying time and start the next operation.
• When the drying time has been set in the software RIP, priority is given to the software RIP's setting.
• If [Drying Time] is set to a value other than [0 min] and [Drying Feed] is off, the machine waits for the set
time at the print-end position before starting the next operation.
MEMO
6.
Tap [Save] to confirm your entry.
7.
Tap to go back to the original screen.
Default setting:
• [Drying Feed (Printing Only)]: Off
MEMO
Adjusting the Ink-drying Method
174
Optimizing the Output Quality