Roland TrueVIS VG-640, User Manual, Page: 50 / 200

Basic Printing Method
2
Basic Operation
48
J
Press [ENTER] to confirm your entry.
If you select "YES," the test pattern (P&C1) is printed and cut again. Go back to step G and perform
the setting again.
If you select "DONE," proceed to the next procedure.
9.
Correct the misalignment of the printing and cutting positions when using crop
marks. (Separate setting
"
P.148
)
MEMO
When you remove the printed media, and then reload it and perform cutting, use the crop marks.
For this case, correction is to be performed because the positioning of printing and cutting may
be misaligned even when you are using crop marks depending on the composition of the media.
A
Press [ ] or [ ] to select "NEXT" or "SET."
Select "NEXT" when you will not print crop marks. Select "SET" when you will print crop marks.
CROP-CUT ADJ.
[SET] NEXT
B
Press [ENTER] to confirm your entry.
If you select "SET," the test pattern (C&C1) is printed and cut. Proceed to the next procedure.
If you select "NEXT," proceed to step
10
.
C
Check the test pattern
(C&C1)
condition.
Check for misalignment in the cutting position and printing position.
Cutting position
Printing position
Printing position and cutting
position are misaligned.
Printing position and cutting
position are aligned.
D
<Cutting position and printing position are not aligned>
Press [ ] to select "YES."
CONTINUE ADJ.?
[YES] DONE
<Cutting position and printing position are aligned>
Press [ ] to select "DONE."
CONTINUE ADJ.?
YES [DONE]