Roland TrueVIS VF2-640, User Manual

Page: 28 / 208

This section explains how to set up opaque media. For details on how to set up transparent media, see "
"Using
Transparent Media(P. 76)"
."
Setup of Roll Media
Load the roll media on the printer. When you have finished loading the media, [SETUP] lights. This work is referred
to as "Setup of Media."
CAUTION
Load the roll media correctly.
Otherwise the media may fall and cause injury.
CAUTION
The roll media is approximately 40 kg (88 lb.). To avoid injury, handle the roll media with
care.
CAUTION
Never load media that weighs over 40 kg (88 lb.).
The machine may tip over because it is incapable of withstanding the weight. Alternatively, the media
may fall out of the machine.
1.
Install the media on the media holders.
The media holders of this machine are designed to be used exclusively with media that has a paper tube (core)
with an inner diameter of 3 inches. To use 2-inch media, the optional media flanges are required. For information
about optional items, contact your authorized Roland DG Corporation dealer or visit our website (
http://
www.rolanddg.com/
).
Procedure
1.
Open the front cover.
2.
Move the media clamps to the outside of the grit rollers on the left and right edges respectively.
3.
Loosen the retaining screws of the media holders, and then draw them to the left and right ends respectively.
Setup of Media
2. Basic Operations
27