20
Connecting the SP-606 to Your
Equipment
For details on USB connections, refer to “Chapter 13. About USB” (p. 83).
fig.connects
Refer to the diagram, and make connections according to the following procedure.
1.
Before you make any connections, switch off the power on all your equipment.
To prevent malfunction and/or damage to speakers or other devices, always turn down the volume,
and turn off the power on all devices before making any connections.
2.
Connect the included AC adaptor to the AC adaptor jack.
To prevent the inadvertent disruption of power to your unit (should the plug be pulled out
accidentally), and to avoid applying undue stress to the AC adaptor jack, anchor the power cord
using the cord hook, as shown in the illustration.
3.
Connect your audio system or amp(s) to the OUTPUT or DIGITAL OUT jacks. If you’re using headphones,
connect them to the PHONES jack.
INPUT
or
DIGITAL IN
jacks.
4.
Plug the AC adaptor into an AC outlet.
3
3
3
2
4
CD/MD Player
When connection cables with resistors are used, the volume level of equipment connected to the
inputs (INPUT, DIGITAL IN) may be low. If this happens, use connection cables that do not contain
resistors, such as those from the Roland PCS series.
Howling could be produced depending on the location of microphones relative to speakers. This can
be remedied by:
1.
Changing the orientation of the microphone(s).
2.
Relocating microphone(s) at a greater distance from speakers.
3.
Lowering volume levels.
SP-606_e.book 20 ページ ２００４年６月２１日 月曜日 午前１０時８分
