Roland RSS Digital Snake S-4000, Owner'S Manual

Page: 56 / 108

6—Using the S-4000 System
56 S-4000 Digital Snake Owner’s Manual
Audio Connections
When making audio input connections with the S-4000S and/or S-4000H units powered on,
always press and hold the MUTE ALL OUTPUTS button on the respective unit’s front panel so
its indicator lights. This will mute the sound coming from the S-4000 System’s audio outputs
and prevent possible damage to connected speakers and other devices. See Page 63 for more
information about MUTE ALL OUTPUTS.
Note that MUTE ALL OUTPUTS only mutes the outputs of the S-4000 System, and not the
outputs of other devices. Before connecting the audio outputs on the S-4000S and S-4000H
units to the audio inputs of other devices, always turn down the volume or turn off the power
on the receiving devices to prevent possible damage.
S-4000S Audio Connections
�������������
���������������
�������������
�����
�������������
������������
�������������������
���������������
The S-4000S’s balanced audio I/O is provided on XLR-type jacks. The wiring diagram for these jacks is
shown in the following illustration. Make connections after first checking the wiring diagrams of other
equipment you intend to connect.
������
���
����
�
�
�
To prevent hazard or damage, ensure that only microphone cables and microphones conforming
to IEC-268-15A are connected.
Afin d’éviter tout risque ou dommage, ne brancher que des câbles
de microphone et des microphones conformes à la norme IEC-268-
15A.