Roland RD-300NX, Owner'S Manual

Page: 85 / 96

85
Appendices
List of Messages
Error Messages
Indication Situation Action
Error 1
You can only read the music file .
You can only read the music file.
It can not be saved.
–
Error 2
An error occurred during writing .
An error occurred during writing.
The external media’s protect tab may be in the
“Protect” (writing prohibited) position, or the
external media may not yet be initialized.
–
Error 10
No storage media is inserted .
No external media is inserted. Insert the external media and try again.
Error 11
Insufficient free memory at the save
destination .
There is not sufficient free memory in the save
destination.
Either use different external media, or delete
unneeded files before you try the operation
again.
Error 14
An error occurred during reading An error occurred during reading.
The external media may be corrupted.
Insert other external media and try again.
Alternatively, you can initialize the external
media.
Error 15
The data format is not compatible with this
instrument .
The file is unreadable. The data format is not
compatible with the RD-300NX.
Only files in the following formats can be used.
•
Live Set files with an extension of “RDS” (*)
•
SMF music files with an extension of “MID”
•
Audio files with an extension of “WAV”
For details on audio file formats, refer to “Types
of audio files that the RD-300NX can play” (p. 86).
Error 16
Data could not be read fast enough for
playback of the song .
Data was not called up in time for playback of
the song.
You may be able to play the song after waiting
a few seconds.
Error 18
The audio data format is not compatible with
this instrument .
This audio format is not supported.
Please use 44.1 kHz 16-bit linear WAV format
audio files.
Error 30
The internal memory capacity of the
RD-300NX is full .
The internal memory capacity of the RD-300NX
is full.
–
Error 40
The instrument can’t deal with the excessive
MIDI data .
The RD-300NX cannot deal with the excessive
MIDI data sent from the external MIDI device.
Reduce the amount of MIDI data sent to the
RD-300NX.
Error 41
A MIDI cable has been disconnected .
A MIDI cable has been disconnected. Connect it properly and securely.
Error 43
A MIDI transmission error has occurred .
A MIDI transmission error has occurred.
Check the MIDI cable and connected MIDI
device.
Error 51
System error . Repeat procedure, or power off,
then on .
There may be a problem with the system.
Repeat the procedure from the beginning. If it
is not solved after you have tried several times,
contact the Roland service center.
Error 65
The USB Memory port was subjected to
excessive current .
The USB MEMORY connector was subjected to
excessive current.
Make sure that there is no problem with the
external media, then turn the power off, then
on again.
(*) The RD-300NX cannot read the setup files or live set files of other models.