Roland Music ATELIER AT75, Owner'S Manual

Page: 22 / 144

20
Before You Start Playing
You can connect a commercially available CD drive and play
back audio CDs and CD-ROMs containing saved SMF music
files.
You can also play songs on VIMA CD-ROMs (VIMA TUNES)
sold by Roland.
Precautions Concerning Use of the CD
• The ATELIER is capable of playing back only commercial
CDs that conform the official standards-those that carry
the “COMPACT disc DIGITAL AUDIO” logo.
• The usability and sound quality of audio discs that
incorporate copyright protection technology and other
non-standard CDs cannot be guaranteed.
• For more detailed information on audio discs featuring
copyright protection technology and other non-standard
CDs, please consult the disc vendor.
• You cannot save songs to CDs, and you cannot delete
songs recorded to CDs. Furthermore, you cannot format
CDs.
The ATELIER does not support CD drives that are powered
by the USB bus. If you use a USB-bus-powered CD drive,
you must use the power supply included with the CD drive
so that the drive will operate under its own power.
1.
Switch off the power to the ATELIER and the CD
drive to be connected.
2.
Connect the USB cable included with the CD
drive to the External Memory connector on the
ATELIER.
3.
Turn on the power to the ATELIER.
4.
Turn on the power to the connected CD drive.
For information on how to perform the following CD-drive
operations, refer to the owner’s manual for the drive.
• Switching the power on and off
• Inserting and ejecting a CD
A list of the CD drives that have been tested and found to be
compatible is available on the Roland website.
http://www.roland.com/
If you feel that the ATELIER has become unstable, for example
after moving it to another location, turn the adjuster located on
the bottom of the stand’s legs as shown in the following.
When turning the adjuster, be careful not to pinch your
hand.
• Rotate the adjustor to lower it so that it is in firm contact
with the floor. Make adjustments so that there is no gap
between the adjuster and the floor. In particular, when
placing the ATELIER on carpet, turn the adjuster so that it
is firmly in contact with the floor.
Using a CD
Connecting a CD Drive
(Sold Separately)
NOTE
External Memory
connector
USB cable
About the Adjuster
NOTE
NOTE
AT-75_e.book 20 ページ ２００８年８月２１日 木曜日 午前１０時９分