Roland monoFabARM-10, User Manual

Page: 20 / 53

Output (Printing)
20
Prepare for Printing
WARNING
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
WARNING
Be sure to perform operations as specified by the instructions below, and never touch any area not specified in the instructions.
The machine may move in an unexpected way, resulting in injury or burns.
WARNING
Do not store photo-curable resin in any of the following locations:
• Any location exposed to open flame
• Any location where high temperature may occur
• Near bleach or any other such oxidizing agent or explosive material
• Any location within the reach of children
Doing so may result in fire. Accidental ingestion by children may pose a health hazard.
WARNING
Never place a photo-curable resin container in fire.
Resin may flow out, catch fire, and spread fire to other nearby objects.
WARNING
Never drink or sniff photo-curable resin or allow it to come in contact with the eyes or skin.
Doing so may be hazardous to the health.
CAUTION
When handling resin, wear rubber gloves and protective eyewear.
Do not allow resin to come into contact with the skin or eyes.
CAUTION
Always close the lid securely when storing a photo-curable resin container.
Failure to do so may result in resin leakage.
Check that the liquid material vat is not dirty
Before starting printing, check that there is no dirt or foreign matter in the liquid material vat (such as fragments remaining from the last printing operation).
If there is dirt or foreign matter, wash the liquid material vat.
For details, refer to
“Wash the liquid material vat” (p. 39).