2
Introduction
Thank you very much for purchasing this product.
•
To ensure correct and safe usage with a full understanding of this product’s performance, please be sure to read through this manual completely and store it in
a safe location.
•
Unauthorized copying or transferral, in whole or in part, of this manual is prohibited.
•
The contents of this operation manual and the specifications of this product are subject to change without notice.
•
The operation manual and the product have been prepared and tested as much as possible. If you find any misprint or error, please inform us.
•
Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may occur through use of this product, regardless of any failure to
perform on the part of this product.
•
Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may occur with respect to any article made using this product.
Company names and product names are trademarks or registered trademarks of their respective holders.
http://www.rolanddg.com/
Copyright © 2014 Roland DG Corporation
Roland DG Corp. has licensed the MMP technology from the TPL Group.
Summary of Contents for monoFabARM-10
