Roland MODELA Pro II ZCL-540, User Manual

Page: 60 / 80

58 Chapter 5 Getting Ready for and Performing Cutting
5-2 Starting Cutting
Overview of the Procedure
This is an overview of the procedures to follow before you start cutting. This section describes a common cutting method
that involves aligning the Y- and Z-axis origins with the center of the A axis.
Set the Y-axis Origin
Perform detection of the A-axis center, then set the Y-axis origin.

P. 43, "4-2 Setting the Y-axis Origin" v
Load the Workpiece and Install the Tool
Before you do this, familiarize yourself with such basic knowledge as how to use the workpiece chuck and the limitations
on workpieces and tools.

P. 31, "Chapter 3 - Basic Operation"

P. 56, "5-1 Cutting Area"
Set the Z-axis Origin
Before you set the Z-axis origin, first install the tool.

P. 48, "4-3 Setting the Z-axis Origin"
Set the Cutting-start Location
Set the X- and A-axis origins to match the workpiece.

P. 59, "Setting the Cutting-start Location"