99
Navigating to this page:
Main Work Page
Press
F4
Functions Page
Select <Machine Setting>
from the menu
Machine Setting Page
Select <Others> from the
menu
Others Page
Machine Setting- Others Page
The Others Page allows you to change various settings that correspond to the control panel. The Language
setting will allow users to change available languages displayed on the control panel.
The Unit setting will allow you to change whether the units displayed by the control panel is in the metric or
imperial system. The EOF (end of file) Alarm setting will enable or disable an audible notification when jobs are
complete. The Air Delay setting allows you to specify the delay in seconds of the SmartAIR air-assist after the
point of laser firing.
•
Language: ENGLISH (others dependent on Firmware)
•
Unit: METRIC/ INCH
•
EOF Alarm: YES/ NO
•
Air Delay: 1-100 seconds
Tip
Depending on the material you are working with, your laser settings, and the desired results, please
experiment with the air delay to achieve your desired results.
Others Page
Relevant Buttons
Function
F1 (Back)
Back to previous page
F4 (Save)
Save your current settings
/
Directional
Scroll through the menu selections
/
Directional
Adjust the value for that selection
Start / Stop
Back to Main Work Page
Auto Focus
Initiate the auto focus function
/
Manual Focus Buttons
Manually adjust the height of the work table (Z-axis)
Summary of Contents for LV-290
