Roland Juno-Stage, User Manual

Page: 91 / 256

91
Chapter 7. Connecting an External MIDI Device
Connection Example
fig.midi-sync_e.eps
1. Press the [MENU].
2. Use [ ] [ ] to select “1. System” and press the [ENTER].
3.
Press [4 (MIDI/SYNC)].
4. Press [5 (SYNC)].
5.
Use the cursor buttons to select the parameter you want to edit.
6. Use the VALUE dial or [DEC] [INC] to edit the value.
7.
To save the settings, press [WRITE].
If you want an external MIDI device to synchronize to the operation of
the JUNO-STAGE, make the following settings.
Synchronizing with an External
MIDI Device
Parameter Range Explanation
Sync
Mode
MASTER,
SLAVE,
REMOTE
Specifies the signal according to
which the JUNO-STAGE will operate.
MASTER:
The JUNO-STAGE will be the master.
Choose this setting if you’re using the
JUNO-STAGE on its own, without
synchronizing to another device.
SLAVE:
The JUNO-STAGE will be a slave
device. Choose this setting if you
want the JUNO-STAGE to operate
according to MIDI Clock messages
received from an external device.
REMOTE:
The JUNO-STAGE will obey Play,
Continue, and Stop MIDI messages
received from an external device,
but will operate according to its
own tempo setting.
Sync
Output
OFF, ON
If this is ON, synchronization-
related MIDI messages (MIDI Clock,
Start, Continue, Stop) will be
transmitted to the external MIDI
device.
Tempo
Override
OFF, ON
If this is ON, the tempo will be
switched to the “Recommended
Tempo” setting of the performance
when you switch performances.
MIDI sequencer
MIDI OUT
MIDI OUT MIDI IN
MIDI IN
JUNO-STAGE
Transmitting Synchronization Data
Parameter Value
Sync Mode MASTER
Sync Output ON
JUNO-STAGE_e.book 91 ページ ２００８年１０月１７日 金曜日 午後１２時２７分