Roland IU-1000F, Operating Instructions Manual

Page: 70 / 144

3. Basic Operations
68
Moving the gantry manually
Click the moving buttons on the toolbar to move the carriage or gantry manually.
This section uses the Y-direction as an example to explain the setting procedure for the moving distance
each time you click a moving button.
1. Click the [Maintenance] tab.
2. Enter the moving distance in the Y direction in [Move Length] from the [Motion] tab.
3. Click [Apply].
Each time you click [Forward] and [Back] on the toolbar, the gantry will move the distance of the set
value.
Capping
You can prevent nozzle clogging due to drying by capping the print heads.
1. Click [Cap] on the toolbar.
The carriage moves to the maintenance station and caps are attached to the print heads.
Detaching caps
When moving the carriage from the maintenance station for measuring the thickness of media, etc., detach
the caps beforehand.
1. Click [Cap] on the toolbar.
Caps are detached from the print heads.