Roland IU-1000F, Operating Instructions Manual

Page: 105 / 144

If a Message Appears
103
If a Message Appears
• An error code will be displayed together in the service call message. Make sure to write down the
error code and contact your authorized Roland DG Corporation representative.
•
Before turning off the power, see page 44 "Turning On/Off the Power".
Message Cause Solution
1: "It is now printing."
"Try again Later. Or abort
software process and restart
program."
The machine is printing. Perform again after printing is
complete. If the same message
still appears, restart Print Control.
4: "Hardware configuration is
incorrect, machine cannot print."
"Contact your equipment
provider, please!"
The operating system does not
support Print Control.
Check the version of Print Control
and the operating system being
used, and contact your authorized
Roland DG Corporation
representative.
5: "Illegal print head voltage
found!"
"Contact your equipment
provider, please!"
An error has occurred in the
carriage or the print heads.
Turn the power to the machine
off and then on again. If the same
message still appears, contact
your authorized Roland DG
Corporation representative.
6: "Carriage height is too low." • The height of the carriage
is too low.
• There is an error with the
height of the carriage.
• The caps is not detached.
• Adjust the height of the
carriage by using the
[Carriage Lifter] tab on the
Print Control
[Maintenance] screen. If
the carriage position error
is too large, click [Lifter
Back Zero], and reset the
height of the carriage.
• Detaching caps
8: "System is busy." The computer being used has
insufficient memory.
Close any unnecessary
applications that are open, and
then restart Print Control.