71
Chapter 7 Other Features
Chapter
7
Keeping Effect Sounds Playing After Patches
Are Switched (Patch Change Mode)
The GT-8 features a mode that is enabled when spatial effects
(such as reverb and delay) are used, whereby the effects
sound of one patch continues playing even after you switch
to the next patch. If the necessary conditions regarding the
effects chain and effect parameter settings are met, you can
then have the decay of reverb, delay, and similar effects
continue on into the next patch after you switch patches.
• Effects are in the same effects chain
• When switching the delay off or on, or when the type
and time are identical
• When switching other effects off or on, or when the
parameter settings are identical
* There still may be no reverberation in some cases, even after
the above settings are made.
fig.07-111
1.
Press [SYSTEM], then press PARAMETER [
]
[
] so that “SYS: P.Chnge Mode” is displayed.
fig.07-120d
2.
Rotate the PATCH/VALUE dial to change the setting’s
value.
3.
Press [EXIT] to return to the Play screen.
Using the Identical Preamp Settings
in All Patches (Preamp Mode)
With the GT-8, you can have a preamp be set globally for use
in all patches.
This provides an effect that always gives you the sound of
the same guitar amp regardless of the patches you set.
fig.07-121
1.
Press [SYSTEM], then press PARAMETER [
]
[
] so that “SYS: Preamp Mode” is displayed.
fig.07-130d
2.
Rotate the PATCH/VALUE dial to change the setting’s
value.
3.
Press [EXIT] to return to the Play screen.
Setting the System Preamp
When the Preamp Mode is set to System, preamp settings
made by adjusting the panel controls are treated as system
preamp settings.
The stored content is updated each time the settings are
changed.
Value
Explanation
Fast
Patches are changed normally. The unit switches to the subse-
quent patch without any carry-over of the decay from the pre-
vious patch’s reverb or chorus.
Smooth
The unit switches to the subsequent patch with the decay from
the previous patch’s reverb or delay continued after the switch
is made.
* For smooth switching, patches may be switched with one tempo
delayed.
1
2
1
3
Value
Explanation
Patch
The patch preamp setting is used. This al-
lows you to use different preamp settings
in each individual patch.
System
The system’s preamp setting is used. This
applies the same preamp settings to all
patches.
1
2
1
3
GT-8_e.book 71 ページ ２００７年６月２９日 金曜日 午後３時５５分
