Roland Groovebox MC-707, Reference Manual

Page: 91 / 121

91
MFX/IFX Parameters
18 Tremolo
Cyclically changes the volume.
L in L out
R out R in
Tremolo Tremolo 2-Band EQ 2-Band EQ
Tremolo Tremolo 2-Band EQ 2-Band EQ
Parameter Value Explanation
Mod Wave
TRI, SQR, SIN, SAW1,
SAW2, TRP
Modulation wave
TRI: Triangle wave
SQR: Square wave
SIN: Sine wave
SAW1/2: Sawtooth wave
TRP:
Trapezoidal wave
SAW1 SAW2
Rate
(sync sw)
OFF, ON
If this is ON, the rate synchronizes with the
tempo of the rhythm.
&
“TEMPO” (p. 52)
Rate
(Hz)
0.05–10.00 [Hz]
Frequency of the change
Rate
(note)
Note
&
“Note” (p. 120)
Depth 0–127 Depth to which the effect is applied
Low Gain -15–+15 [dB] Gain of the low range
High Gain -15–+15 [dB] Gain of the high range
Level 0–127 Output Level
19 Auto Pan
Cyclically modulates the stereo location of the sound.
L in L out
R out R in
Auto Pan Auto Pan 2-Band EQ 2-Band EQ
Auto Pan Auto Pan 2-Band EQ 2-Band EQ
Parameter Value Explanation
Mod Wave
TRI, SQR, SIN, SAW1,
SAW2, TRP
How the pan changes
TRI: Triangle wave
SQR:
Square wave
SIN:
Sine wave
SAW1/2: Sawtooth wave
TRP: Trapezoidal wave
SAW1 SAW2
R R
L L
Rate
(sync sw)
OFF, ON
If this is ON, the rate synchronizes with the
tempo of the rhythm.
&
“TEMPO” (p. 52)
Rate
(Hz)
0.05–10.00 [Hz]
Frequency of the change
Rate
(note)
Note
& “Note” (p. 120)
Depth 0–127 Depth to which the effect is applied
Low Gain -15–+15 [dB] Gain of the low range
High Gain -15–+15 [dB] Gain of the high range
Level 0–127 Output Level
20 Slicer
By applying successive cuts to the sound, this effect turns a
conventional sound into a sound that appears to be played as a
backing phrase. This is especially effective when applied to sustain-
type sounds.
L in L out
R out R in
Slicer Slicer
Slicer Slicer
Parameter Value Explanation
Step 01–16 0–127 Level at each step
Rate
(sync sw)
OFF, ON
If this is ON, the rate synchronizes with the
tempo of the rhythm.
&
“TEMPO” (p. 52)
Rate
(Hz)
0.05–10.00 [Hz]
Rate at which the 16-step sequence will cycle
Rate
(note)
Note
& “Note” (p. 120)
Attack 0–127
Speed at which the level changes between
steps
Input Sync Sw OFF, ON
Specifies whether an input note will cause
the sequence to resume from the first step of
the sequence (ON) or not (OFF)
Input Sync Threshold 0–127
Volume at which an input note will be
detected
Mode LEGATO, SLASH
Sets the manner in which the volume
changes as one step progresses to the next.
LEGATO: The change in volume from one
step’s level to the next remains unaltered. If
the level of a following step is the same as
the one preceding it, there is no change in
volume.
SLASH:
The level is momentarily set to 0
before progressing to the level of the next
step.
This change in volume occurs even if the
level of the following step is the same as the
preceding step.
Shuffle 0–127
Timing of volume changes in levels for even-
numbered steps (step 2, step 4, step 6...).
The higher the value, the later the beat
progresses.
Level 0–127 Output Level