Roland FP-4, Owner'S Manual

Page: 90 / 140

90
Settings
This setting determines whether or not the chords are indicated
in the display during performances using Session Partner.
1.
Press the [Function] button.
2.
Press the [Session Partner] button.
3.
Hold down the [Session Partner] button and
use the [-] [+] buttons to get “chd” to appear in
the display.
fig.d-chd.eps
4.
Use the [-] [+] buttons to change the setting.
The FP-4 contains a storage area in which you can save your
recorded performances or your registration sets. This area is
called “internal memory.”
If you want to erase the entire contents of internal memory and
restore it to the factory-set condition, execute the following
procedure.
1.
Press the [Function] button.
2.
Press the Track [2] button.
While you hold down the Track [2] button, the display
will indicate “FMt.”
fig.d-Format.eps
When you take your finger off the Track [2] button, a
confirmation message will appear.
fig.d-Sure.eps
If you press the [Play] button once again, you will return
to the previous screen without initializing.
3.
Press the [Rec] button.
Initialization will begin.
The entire contents of internal memory will be erased.
* Never turn off the power before the screen indicates
“End.” Doing so may destroy the FP-4’s memory,
rendering it unusable.
This operation will not initialize any settings other
than the contents of internal memory. If you want to
return settings other than internal memory to the
factory-set state, please execute Factory Reset (p.
91).
Setting the Chord Display On or Off
Setting Description
Chords are displayed.
Chords are not displayed.
Initializing (Formatting)
Memory
Initializing Internal Memory
NOTE
FP-4-e.book 90 ページ ２００７年５月２４日 木曜日 午後７時１０分