‑
5
Connecting Equipment (Rear Panel)
Turning On/Off the Power
Once everything is properly connected, be sure to follow the procedure
below to turn on their power. If you turn on equipment in the wrong
order, you risk causing malfunction or equipment failure.
Turning the power on
1
Long-press the [
L
] (Power) button to turn the power on.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after turning the unit on is required before it will operate
normally.
* Before turning the unit on/off, always be sure to turn the volume down. Even with
the volume turned down, you might hear some sound when switching the unit on/
off. However, this is normal and does not indicate a malfunction.
Turning the power off
1
Hold down the [
L
] (Power) button for one second or
longer; the power will be turned off.
* Do not disconnect the power cord while the [
L
](power) button is blinking.
Making the Power Automatically Turn Off After a Time (Auto Off)
The power to this unit will be turned off automatically after a
predetermined amount of time has passed since it was last used for
playing music, or its buttons or controls were operated (Auto Off
function).
If you do not want the power to be turned off automatically, disengage
the Auto Off function. (Default: 240 min.)
* Auto-off settings are automatically saved in this unit.
Hold down
240 min
Off
10 min
30 min
2
1
5
Any settings that you are in the process of editing will be lost when the power is
turned off. If you have any settings that you want to keep, you should save them
beforehand.
5
To restore power, turn the power on again.
DC In jack
Connect the included AC adaptor.
AC Outlet
Power Cord
Place the AC adaptor so the side with the indicator (see
illustration) faces upwards.
The indicator will light when you plug the AC adaptor into
an AC outlet.
Pedal 1 jack
Connect the included
damper pedal.
USB Memory port
Connect a USB flash drive (sold separately).
If a USB flash drive is connected, you can play or save songs.
*
Never turn off the power or disconnect a USB flash drive
or the power cord
while the access indicator of the USB flash
drive is blinking.
* Taking care to observe the correct direction and orientation,
insert the USB flash drive all the way into the port. Do not use
excessive force.
USB Computer port
Here you can connect your computer via a
USB cable (sold separately). If your computer
is connected, performance data can be
transferred between the piano and sequencer
software (sold separately) on your computer,
allowing you to produce or edit music.
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
Cord hook
* Use the cord
hook to secure
the cord of the
AC adaptor as
shown in the
illustration.
Amplified speakers
You can connect amplified
speakers and hear the sound
of the piano through them.
* If the sound is distorted
when external speakers are
connected, slightly lower
the volume of the FP-30X.
Pedal 2 jack
If connecting the dedicated pedal (KPD-70: sold separately) to the
dedicated stand (KSC-70: sold separately), connect the KPD-70’s cable
here.
Damper Pedal
Use this pedal to sustain the sound.
Sostenuto Pedal
The notes you are pressing when this
pedal is depressed will be sustained.
Soft Pedal
This pedal is used to make the sound
softer.
* When operating the pedal, take care not to pinch your fingers between the moving part and the body of
the unit. Pay special attention to this when using the unit where children are present.