261
Sampling
Over
view
Sound 1
Sound 2
Sound 3
Pad
Sampler
Menu/System
Appendix
Sequencer
•
Sampling Length
You can specify this if Stop Trigger is “BEAT” or “TIME.”
Value
When Stop Trigger is “BEAT”:
1–20000: Number of beats to continue sampling
When Stop Trigger is “TIME”:
000’00”010–107’47”000: length of time to continue sampling
By holding down [SHIFT] and turning the VALUE dial you can
adjust this in steps of one second.
•
Auto Trigger Level
Specifies the volume at which sampling will begin if you have
pressed [F2 (Auto Trig)] to turn Auto Trig ON.
Value:
0–7 (A setting of 0 is the minimum.)
•
Gap Time
Specifies the length of the silences at which the sample will be
divided if the Sampling Mode is set to Auto Divide. Whenever
there is a silent region longer than the specified time, the sample
will be divided at that point, and the next sample number will
be assigned to the sound that follows.
Value:
500, 1000, 1500, 2000 ms
*
This parameter is valid only when you are using Auto Divide
Sampling.
•
Input Setting: [F1 (Inp Setting)]
Makes settings for the external input (p. 258).
•
Auto Trigger Sw: [F2 (Auto Trig)]
If this is on, sampling will begin automatically when the input
sound is detected.
Before you turn Auto Trig on, perform steps 4 and 5 to set the
input level.
•
Trim Sw: [F3 (Trim Sw)]
If this is turned on, the Start point and End point settings (p.
267) will be automatically adjusted after sampling is performed,
so any silent portions at the beginning or end of the sampled
sound are excluded.
4.
Play the external input source.
5.
If you use AUDIO INPUT, turn the LEVEL knob (rear panel:
p. 24) to adjust the volume.
*
If you’re using DIGITAL IN, this adjustment is not necessary.
*
If the volume of the external source is too high, the PEAK indicator
will light. If this occurs, turn down the LEVEL knob until the PEAK
indicator no longer lights.
*
If the level of the sound to be sampled is too high, the word “CLIP”
will appear in the level meter in the screen.
*
Using a connection cable that contains a resistor can cause the sound
level to be low. Use a connection cable that does not contain a resistor.
6.
Press [F8 (Start)] to begin sampling.
*
If the Auto Trigger setting is on, sampling will begin as soon as sound
is input.
7.
If Stop Trigger is set to MANUAL, press [F7 (Stop)] to stop
sampling.
The Sample Edit (p. 266) screen will appear.
*
If you want to edit the sample, refer to p. 263.
fig.14-007_50
When you finish sampling, the sample will automatically be
added to the sample list. Press [F1 (Sample List)] to view the
sample list.
fig.14-008_50
Samples you record will be lost when you turn off the
power.
If you want to keep your sample, press [F2 (Save)] to
Samples without the “
” symbol and samples with the “
”
symbol have not been saved.
8.
Press [EXIT] to go back to where you were before you
entered the Sampling screen.
Fantom-G_r_e.book 261 ページ ２００９年７月２日 木曜日 午後２時５５分
