![background image](http://html1.mh-extra.com/html/roland/egx-300/egx-300_replacement-manual_1480199001.webp)
Motor cover
Spindle cover
1
3
5
Turn the Z-adjust screw in the direction
of the arrow to release.
Turn the Z-adjust screw in the direction
of the arrow to lock.
Use a hexagonal wrench (1.5 mm) to
loosen the mounting screws, and replace
the spindle.
Provisionally secure the motor cover in
place.
Remove the cover for the carriage.
(A Phillips screw driver is required.)
Remove the spindle belt and spindle tip.
2
Remove only
when replacing
the ZS-23
Spindle belt
Loosen the four screws
Motor cover
Spindle cover
Motor cover
Secure the motor cover in place.
Take care to ensure that
t h e m o t o r c o v e r a n d
s p i n d l e c o v e r d o n o t
touch.
Tighten the screws to
install the spindle cover
so that it is positioned
at "0."
6
Z-adjust screw
Z-adjust screw
View as seen from
the left of the unit
Top view
For PNC-2300/EGX-300
ZS-23 Spindle Unit and ZM-23 Motor Replacement Guide
ZS-23
ZM-23
9
8
7
4
Spindle tip
Spindle
Switch on the power to the unit and
make sure that the spindle cover is
positioned at "0."
R e m o v e t h e o l d s p i n d l e m o t o r
and replace with the new motor. If
n e c e s s a r y, a l s o r e p l a c e t h e m o t o r
brushes (see the user's manual) and the
spindle belt.
M3 x 4
M3 x 6
M3 x 4
Roland DG corporation
R4-020618