Installation
34
2. Installation and Setup
2. Installation and Setup
Removing the Retainers
Retainers are attached to protect the machine from vibration during shipment. When installation is complete,
remove and save these retainers.
There are four retainers attached (retainers A, B, C, and D). Remove all retainers. Any that remain may cause
faulty operation or a breakdown when the power is switched on.
The retainers will be required when moving the machine to a different location. Store them carefully so
that they do not get misplaced.
When removing the retainers, make sure the power cord is not connected.
Retainer A
Retainer B
Retainer C
Retainer D
Procedure
Open the front cover.
Remove retainer A.
As shown in the figure, push the side of retainer A that is touching retainer B toward
the inside to change the shape of retainer A.
Pull the retainer forward in this deformed shape.
Pulling the retainer forward without changing the shape will cause it to catch on the uneven area inside
the machine and prevent it from being removed.
Retainer B
Retainer A
Hold this with
both hands.
