32
2. Installation and Setup
2. Installation and Setup
2. Installation and Setup
Installation
Placement and Installation
The weight of the machine alone is 53 kg (117 lb.). Unload and place with care.
WARNING
Unloading and placement are operations that must be performed by 2
persons or more.
Tasks that require undue effort when performed by a small number of persons
may result in physical injury. Also, if dropped, such items may cause injury.
CAUTION
When lifting the machine, hold the locations shown in the figure.
Installation Environment
WARNING
Install the machine in a location that is level, stable, and able to bear the
weight of the machine.
The total weight of the machine may reach 58 kg (128 lb.) or more. Installation in an
un-suitable location may cause a major accident, including a tip over, fall, or collapse.
WARNING
Never install in a location exposed to open flame.
Milling waste may ignite. Powdered material is extremely flammable, and even
metal material may catch fire.
WARNING
Never install close to any flammable object or in a gas-filled location.
Combustion or explosion may occur.
WARNING
Never install outside or in any location where exposure to water or high
humidity may occur.
Doing so may result in fire or electrical shock.
WARNING
Position the machine so that the power plug is within immediate reach
at all times.
This is to enable quick disconnection of the power plug in the event of an emer-
gency. Install the machine next to an electrical outlet. Also, provide enough
empty space to allow immediate access to the electrical outlet.
Never install in a location subject to wide fluctuations in temperature or humidity.
Never install in a location subject to shaking or vibration.
Never install in a dusty or dirty location.
Never install in a location exposed to direct sunlight or near air-conditioning or heating equipment.
Never install in a location exposed to considerable electrical or magnetic noise, or other forms of electromagnetic energy.
Never install in an environment where silicone substances (oil, grease, spray, etc.) are present. Doing so may cause poor switch contact or damage.