Chapter 3 Basic Operation
3-2 Moving the Tool
Chapter 3 Basic Operation
57
Moving to a Specific Position
Selecting a destination from the list and clicking the
[Move] button makes the tool move rapidly to the
selected location. Clicking the [Stop] button stops
movement.
Note: Movement to "Rotation Center Y" is possible only when
detection of the jig location has been performed and the center
of the axis of rotation has been established.
When "User Specify" Is Selected
Clicking the [Move] button makes the window shown at left ap-
pear. You can specify the location of the movement destination
by entering the values you want for "Coordinates" or "Amount
of relative movement."
Moving to the VIEW Position
Press the VIEW button on the built-in panel.
The tool moves to the highest position, after which the table
moves to the front of the machine. This location is called
the "VIEW position." You use this when performing such op-
erations as attaching or detaching a tool, installing a jig, or
mounting a workpiece. The READY light flashes while move-
ment is in progress. When the READY light stops flashing and
remains steadily lighted, movement is complete.
This operation cannot be performed while a front cover is
open. Close the front cover, then perform the operation.
