Roland Camm-1Pro GX-300, User Manual

Page: 78 / 102

Maintenance
4
Ma
inte
na
nce
/ F
AQ
76
Blade protector
If cutting is carried out when the amount of blade extension or blade force is not adjusted correctly, the blade
tip may pierce the material’s carrier paper, resulting in damage to the blade protector. Performing cutting with
a damaged blade protector may make attractive cutting impossible.
When the surface of the blade protector is deformed by scratching or the like, it is necessary to replace the
blade protector. Contact your authorized Roland DG Corp. dealer.
How to Replace the Separating Knife
CAUTION
Make sure the power to the unit isoff before attempting to replace the
separating knife.
Doing so may result in injury.
If the separating knife is not sharp enough to cut attractively, replace it with the replacement knife included
with this machine. Follow the steps below to replace the knife.
Procedure

Switch off the power to the machine.

Remove the separating knife.
Loosen the screw until it slips out.
Grasp the screw portion, and slowly pull
it out in the direction of the arrow.
Do not pull back while doing this.

Replace with a new knife.
The knife is secured in place by the magnet.
* If the blade remains in the carriage,
use tweezers to remove it.
Positioning groove
Magnet