20
Before You Start Playing
Using Headphones
The AT-90SL features a Phones jack. This allows you to play
without having to worry about bothering others around you,
even at night.
fig.00-29
1.
Connect your headphones to the [Phones] jack
underneath the left side of the keyboard.
The sound from the built-in speakers stops.
Now, sound is heard only through the headphones.
fig.00-30
2.
Adjust the headphones volume with the [Master
Volume] slider and Expression pedal.
Accepts connection of Stereo headphones.
Some Notes on Using Headphones
fifig.00-31
• To prevent damage to the cord, handle the headphones
only by the headset or the plug.
• Headphones may be damaged if the volume is too high
when they are plugged in. Lower the volume on the AT-
90SL before plugging in headphones.
• To prevent possible auditory damage, loss of hearing, or
damage to the headphones, the headphones should not
be used at an excessively high volume. Use the
headphones at a moderate volume level.
Using a Microphone
The AT-90SL is equipped with a Mic jack.
Since this instrument has a Mic In jack, you can use a
microphone to enjoy a variety of possibilities such as singing
along with your performance, or singing along with SMF
music files (sold separately).
fig.00-32
1.
Connect your microphone to the [Mic In] jack
underneath the left side of the keyboard.
2.
Use the [Mic Volume] knob to adjust the volume
level for the microphone.
You can adjust the depth of the echo applied to sound from
the microphone (p. 195).
The microphone must be purchased separately. When
purchasing a microphone, please consult the vender where
you bought the AT-90SL.
NOTE
If the Input switch is set to “RSS,” RSS reverb will be applied
to the sound from the microphone. You can use the [Mic
Volume] knob to adjust the microphone volume (p. 210).
Some Notes on Using a Microphone
fig.00-31
• To avoid disturbing others, be careful of the volume
level when playing late at night or very early in the
morning.
• When connecting a microphone to the AT-90SL, be sure
to lower the volume. If the volume control is too high
when the microphone is plugged in, noise may be
produced by the speakers.
• Howling could be produced depending on the location
of microphones relative to speakers. This can be
remedied by:
• Changing the orientation of the microphone.
• Relocating the microphone so it is farther from the
speakers.
• Lowering volume levels.
Phones
AT-90SL_e.book 20 ページ 2004年9月8日 水曜日 午後5時44分
Summary of Contents for Atelier AT-90SL
Page 1: ...04 9 3N 03676678...
Page 263: ...262 MEMO AT 90SL_e book 262...
Page 266: ...04 9 3N 03676678...