26
Before You Start Playing
Songs you record on the ATELIER and Registration sets you
create can be copied to separately available USB memory for
safekeeping. You can also copy songs to a floppy disk using a
separately sold floppy disk drive (p. 97, p. 126
You can also play back SMF music files saved on USB
memory or a floppy disk (p. 167).
Use USB memory and floppy disk drive available from
Roland. Proper operation cannot be guaranteed if other USB
device is used.
1.
Connect the USB memory to the External
Memory connector.
Carefully insert the USB memory all the way in—until it is
firmly in place.
If you’re using new USB memory or floppy disk, you’ll need
to initialize (format) it on the ATELIER. For details, refer to
“Formatting a USB Memory (Format)” (p. 233).
You can also use the following method to return to the
factory-set condition.
Method 1
1.
Touch <Quick Guide> on the Main screen,
to display the Quick Guide screen.
2.
Press the [One Touch Program] button.
The confirmation message appears on screen.
fig.00-40-1.eps
If you touch <Cancel>, the Factory Reset will not be
performed, and you will return to the Main screen.
3.
When you touch <OK>, the Factory Reset
operation will begin, and the settings will
return to the factory-set condition.
Method 2
1.
Turn down the volume to the minimum
level, then turn off the power.
2.
While holding down the [One Touch
Program] button, press the [Power On]
switch to turn the power on.
fig.00-41.eps
The following screen appears.
fig.00-40-3.eps
Using the External Memory
Connecting the USB Memory
NOTE
AT-800_e.book 26 ページ ２００８年１０月１５日 水曜日 午前９時３７分
