[CH] CHORUS
1. CH SW
(0 -1)
OFF, ON
Switches chorus on/off. This is a mono/stereo effect.
2. CH MODE
(0 - 2)
MONO
This chorus effect outputs the same sound from both L
channel and R channel.
STEREO1
This is a stereo chorus effect that adds different chorus
sounds to L channel and R channel.
STEREO2
This stereo chorus uses spatial synthesis, with the direct sound
output in L channel and the effect sound output in R channel.
Left-channel -only operation can be obtained by bringing
chorus effect level to 0.
3.
CH RATE
(0 - 100) 8000 – 20ms
Adjust the speed of the chorus effect. When BPM sync
is turned on, this parameter is disabled.
4. CH BPM SYNC
(0 - 20)
OFF, 2, 3/2, 4/3, 1, 3/4, 2/3, 1/2, 3/8, 1/3, 1/4, 3/16,
1/6, 1/8, 3/32, 1/12, 1/16, 3/64, 1/24, 1/32, 3/128
5. CH DEPTH
(0 - 100)
Determines the depth of the chorusing effect.
6. CH PRE DELAY
(0 - 80) 0 – 80ms
Adjusts the time from when the direct sound is heard until the
chorus sounds are heard.
7. CH HPF
(0 - 17) Flat – 800Hz
Cuts the frequency range below the cutoff frequency.
No effect:0.
8. CH LPF
(0 - 14) 630Hz – Flat
Cuts the frequency range above the cutoff frequency.
No effect: 14.
9. CH EFFECT LEVEL
(0 - 100)
Adjusts the volume of the chorus effect.
[FL] FLANGER
1. FL SW
(0 -1)
OFF, ON
Switches flanger on/off. This is a stereo effect.
2. FL RATE
(0 - 100) 8000 – 20ms
Adjusts the rate of the flanging effect. When BPM
sync is turned on, this parameter is disabled.
3.
FL BPM SYNC
(0 - 20)
OFF, 2, 3/2, 4/3, 1, 3/4, 2/3, 1/2, 3/8, 1/3, 1/4, 3/16,
1/6, 1/8, 3/32, 1/12, 1/16, 3/64, 1/24, 1/32, 3/128
4. FL DEPTH
(0 - 100)
Determines the depth of the flanging effect.
5. FL MANUAL
(0 - 100) -50 – 50
Adjusts the center frequency at which to apply the effect.
6. FL RESONANCE
(0 - 100)
Determines the amount of resonance (feedback). Increasing the value will
emphasize the effect, creating a more unusual sound.
7. FL SEPARATION
(0 - 100)
Adjusts the diffusion. The diffusion increases as the value increases.
8. FL HPF
(0 - 10) Flat – 800Hz
Cuts the frequency range below the cutoff frequency.
No effect: 0.
9. FL EFFECT LEVEL
(0 - 100)
Adjusts the volume of the flanger.
10. FL DIRECT LEVEL
(0 -100)
Adjusts the volume of the direct sound.
