Roland A-49, Owner'S Manual

Page: 40 / 56

Changing the A-49 Settings
40
Changing the Direction of Value Increases for the Knobs,
D-BEAM Controller, Buttons, and Pedals (CTRL DIR)
Operate either
Button Setting Explanation
[+] button
POSITIVE
(default)
Moving the knob toward the right will increase the value. Moving
your hand closer to the D-BEAM controller will increase the value, and
moving it away from the D-BEAM controller will decrease the value.
Pressing a button will increase the value. Pressing a pedal will increase
the value.
[–] button REVERSED The opposite will occur.
Selecting the Dedicated Driver or the Generic Driver
Normally, you can leave this set to “ADVANCED.”
Button Setting Explanation
[+] button
ADVANCED
(default)
The dedicated driver described in “Driver Installation” (p. 13) will be
used.
[–] button GENERIC
The generic driver provided by the operating system will be used.
This is convenient if you don’t have the dedicated driver, or if you’re
unable to install the dedicated driver.
* After changing the setting, disconnect the unit’s USB cable, and then reconnect it to reflect
setting.