Rohm Lapis EASE1000 V2, User Manual

Page: 28 / 33

EASE1000 V2 User’s Manual
5.4 About Flash Writing
Confirm before using EASE1000 V2 as a flash writer that the target LSI power supply voltage (V
DD
) is within the
operating conditions of the flash memory. When connecting the ML610QXXX or ML620QXXX as target LSI,
please confirm that the voltage of flash programming power supply (Vpp) and internal logic power supply
(VDDL) are also within the operating conditions of the flash memory.
For the operating conditions of flash memory, refer to “Electrical Characteristics -> Operating Conditions of Flash
Memory” and “On-Chip Debug Function -> Method of Connecting” in the user’s manual for the target LSIs.
Also, please confirm that the application program operates normally after writing.
5.5 About Cables
Be sure to use the USB cable and EASE1000 V2 interface cable supplied as EASE1000 V2 accessories. The
operation is not guaranteed if a cable other than the EASE1000 V2 accessories is used.
Note
Be sure to use the cables attached to EASE1000 V2.
Using different cables may cause fire, electric shock or failure.
27