60 / 341 - EN -
5.2.
Quick start guide
•
Switch on and wait for the kiln temperature display.
•
Call up firing programs with the
g
key.
•
Select the firing program with the
f
or
d
key.
•
To start the selected program, press the
j
key.
•
To stop the firing at any time, press the
j
key again.
•
The firing data and the programming mode can be called up again with the
g
key.
•
Change the firing data and change the displayed value with the
f
or
d
keys.
•
Use the
g
key again as necessary to step to the next firing value or segment to be reviewed or changed.
•
Use the
h
key to switch back to the previous value.
•
To mark the end of a program, set the ramp rate to END with the
f
key.
•
To exit programming mode, either wait 20 seconds or press the
j
key to start firing.
•
If the keyboard is locked, press the
<
key and hold it for 5 s.
6.
Operation & use
6.1.
Display screens after switching on
Display screens after switching on:
Step
Indicator
on the left
Main display
Heating
zone display
on the right
Description
1
ROHDE
•
After switching on, the controller carries out a
display test.
•
All indicators light up.
•
The controller will sound a short beep.
2
F 6.00
•
The controller displays the version number of the
integrated software.
•
When contacting technical customer support, you
will need:
−
the version number
−
the serial number of the device
3
T/C: S
•
The thermocouple type setting is now displayed.
•
This should match the type of thermocouple fitted
to the kiln and can be R, S, K or N.
4
20 °C
•
The final display shows the kiln temperature
(heating zone 1).
•
Apart from the heating zone display and the current
temperature in the main display, no indicators or
icons should light up after switching on.
5
19 °C
The kiln temperature for the other heating zones can
be displayed with the
f
or
d
keys (available if the
controller has been configured for a multi-zone kiln).
6
21 °C
Summary of Contents for ST 630
Page 344: ...20220531 01 ...