Rohde ELS 1000 S, Original Operating Instructions

Page: 100 / 138

99 / 136 - EN -
8.5. Emergency-Stop switch
8.5.1. Emergency-Stop for ELS 150-ELS 480 without eDrive
ELS 150-ELS 480 without eDrive must be switched off with the appropriate mains circuit breaker to shut down in an
emergency (Emergency-Stop).
⇒ When the mains circuit breaker is tripped, the entire kiln is de-energised.
⇒
To reset the “Emergency-Stop” function, the mains circuit breaker must be reset again. The kiln is switched on
again and fully supplied with power at the same time.
8.5.2. Emergency-Stop for ELS 750 & ELS 1000/ELS with eDrive
The main switch also serves as a guard with the “Emergency-Stop” function.
⇒ When the “Emergency-Stop” function is activated, the entire kiln is de-energised.
⇒
To trigger the “Emergency-Stop” function, the main switch must be set to “0/OFF”.
⇒
To reset the “Emergency-Stop” function, the main switch must be set to “I/ON”. The kiln is switched on again
and fully supplied with power at the same time.
8.6. Control unit operation
Figure 13: Supplied control systems (standard)
Optionally, the kiln can also be equipped with type ST 411 and ST 630/ST 632 control systems.
Figure 14: Supplied control systems (optional)
WARNING
An incorrectly placed control unit can lead to
serious personal injury or property damage.
⇒
Make sure that the control system is
never placed on the kiln, but only
positioned in the bracket provided for it.
The kiln is supplied ready for operation by the manufacturer with
the preconfigured TC 304 or TC 504 control unit, including the
necessary program and controller settings.
⇒
It is essential that you first read the relevant instruction
manual for the control system carefully!
TC 304
TC 507
The optionally available control systems are also
delivered ready for operation including the necessary
program and controller settings.
⇒ It is essential that you first read the relevant
instruction manual for the control unit
carefully!