R&S ZVL
Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
533
increment/decrement the source power in 0.1-dB steps.
*RST value
–10 dBm
SCPI, Command
Types
Confirmed, command or query
Example:
FUNC "XFR:POW:RAT B1, A2"
Activate a frequency sweep and select the ratio B1/A2 as measured parameter
for channel and trace no. 1.
SOUR:POW -6
Set the internal source power for channel 1 to -6 dBm.
STATus...
This subsystem controls the Status Reporting System. Note that *RST does not influence the status
registers.
STATus:PRESet
Configures the status reporting system such that device-dependent events are reported at a higher level.
The command affects only the transition filter registers, the ENABle registers, and queue enabling:
The ENABle parts of the STATus:OPERation and STATus:QUEStionable... registers are set to all
1's.
The PTRansition parts are set all 1's, the NTRansition parts are set to all 0's, so that only positive
transitions in the CONDition part are recognized.
The status reporting system is also affected by other commands, see
Reset Values of the Status
Reporting System
.
*RST value
–
SCPI, Command Types
Confirmed, no query
Example:
STAT:PRES
Preset the status registers.
STATus:QUEStionable:CONDition?
Returns the contents of the CONDition part of the QUEStionable register. Reading the CONDition
registers is nondestructive.
*RST value
–
SCPI, Command
Types
Confirmed, query only
Example:
STAT:QUES:COND?
Query the CONDition part of the QUEStionable register to check for
