Rohde & Schwarz ZNL Series, User Manual

Page: 66 / 240

Analysis
R&S
®
ZNL
66 User Manual 1178.5989.02 ─ 06
Remote command:
CALCulate<n>:SPECtrogram:THReedim[:STATe]
on page 166
Select Frame
Selects a specific frame, loads the corresponding trace from the memory, and displays
it in the Spectrum window.
Note that activating a marker or changing the position of the active marker automati-
cally selects the frame that belongs to that marker.
This function is only available in single sweep mode or if the sweep is stopped, and
only if a spectrogram is selected.
The most recent frame is number 0, all previous frames have a negative number.
For more details see the R&S ZNL User Manual.
Remote command:
CALCulate<n>:SPECtrogram:FRAMe:SELect
on page 164
History Depth
Sets the number of frames that the R&S ZNL stores in its memory.
The maximum number of frames depends on the "Sweep Points" on page 55.
For an overview of the maximum number of frames depending on the number of
sweep points, see the R&S
ZNL User Manual.
If the memory is full, the R&S ZNL deletes the oldest frames stored in the memory and
replaces them with the new data.
Remote command:
CALCulate<n>:SPECtrogram:HDEPth
on page 164
3-D Display Depth
Defines the number of frames displayed in a 3-dimensional spectrogram.
For details see the R&S ZNL User Manual.
Time Stamp
Activates and deactivates the timestamp. The timestamp shows the system time while
the measurement is running. In single sweep mode or if the sweep is stopped, the
timestamp shows the time and date of the end of the sweep.
When active, the timestamp replaces the display of the frame number.
Remote command:
CALCulate<n>:SPECtrogram:TSTamp[:STATe]
on page 167
CALCulate<n>:SPECtrogram:TSTamp:DATA?
on page 166
Color Mapping
Opens the "Color Mapping" dialog.
For details see the R&S ZNL User Manual.
Continuous Sweep / Run Cont
After triggering, starts the sweep and repeats it continuously until stopped. This is the
default setting.
Spectrogram Settings